fish eyes

Posted by Eventually

on Sun, Oct 23 2016 5:19 PM

I just finished building a turntable and started painting it. The finish has quite a few very small fish eyes in it. I think I know the source, but am not sure how to proceed from here. Will I need to sand, wash, etc before recoating?

Thanks

Replies to this thread are ordered from "oldest to newest". To reverse this order, click here.
To learn about more about sorting options, visit our FAQ page.

Posted by richg1998

on Mon, Oct 24 2016 10:48 AM

Note, right above this forum is, this is not the Model Railroader forum.

Your question should probably be in the Model Railroader forum below.

http://cs.trains.com/mrr/f/11.aspx

Even the Model Railroader General Discussion forum would be ok.

Did you take time to look through all the different forums here?

Rich

If you ever fall over in public, pick yourself up and say “sorry it’s been a while since I inhabited a body.” And just walk away.

Posted by Eventually

on Mon, Oct 24 2016 12:59 PM

Sorry Rich. I didn't see the note until after I posted.