I just finished building a turntable and started painting it. The finish has quite a few very small fish eyes in it. I think I know the source, but am not sure how to proceed from here. Will I need to sand, wash, etc before recoating?
Thanks
Note, right above this forum is, this is not the Model Railroader forum.
Your question should probably be in the Model Railroader forum below.
http://cs.trains.com/mrr/f/11.aspx
Even the Model Railroader General Discussion forum would be ok.
Did you take time to look through all the different forums here?
Rich
If you ever fall over in public, pick yourself up and say “sorry it’s been a while since I inhabited a body.” And just walk away.
Sorry Rich. I didn't see the note until after I posted.