Since nobody else appears to want to tell him, I will:
If this is a driving wheel that has slipped, you MUST quarter it correctly AND KEEP IT QUARTERED THE WHOLE TIME THE GLUE SETS UP.
'Correctly' on a toy train means 'the same angle between pins that the other two driver pairs have'. It does NOT mean you have to make all three pairs perfectly 90 degrees.
Now go over to the Classic Toy Train community and they will have a wealth of advice on these engines...
GN24:
Do you still have the box it came in? There should be instructions with your engine.
MisterBeasley Welcome to this forum! We are primarily HO and N-scale modelers here. Is this a Lionel HO scale model? If it's O scale, you should probably check out the Classic Toy Trains forum. In any case a drop of CA (cyanoacrylate or Superglue) would be my suggestion. Be careful. It sets quickly so you must set it right the first time.
Welcome to this forum!
We are primarily HO and N-scale modelers here. Is this a Lionel HO scale model? If it's O scale, you should probably check out the Classic Toy Trains forum.
In any case a drop of CA (cyanoacrylate or Superglue) would be my suggestion. Be careful. It sets quickly so you must set it right the first time.
Are talking postwar or the celebration series remake? I have alll postwar
Shane
A pessimist sees a dark tunnel
An optimist sees the light at the end of the tunnel
A realist sees a frieght train
An engineer sees three idiots standing on the tracks stairing blankly in space
It takes an iron man to play with a toy iron horse.
I just recently got a lionel 2026 steam engine in the mail and its wheel slipped off the axle I was able to get it back on for now but I am going to need a stronger adhesive to hold the wheel on. do you guys have any sudgesstions?