I thought they would have the same issue but never used the 1 switch it on my shelf.
Springfield PA
I don't use a Switch-8 but have had occasional problems with a Switch-It, which can control 2 tortoise motors, losing its address and having to be re-programmed after a power glitch.
Mine had a problem where they lost their programming sometimes when there was a short.
Try re-programming the outputs like when you first set it up. Install the jumper, dial up the output on the rotary and address a switch.
I finally fixed mine by installing an auxiliary DCC booster and ran a separate bus to the switch-8's.,
Motley take note.
I have had my switch 8 for a couple of years controlling 5 tortoises. This morning, one and two work normally but 3, 4, & 5 are innoperative. Wires seem intact. Where do I start? I am using NCE pro cab to control the Sw8.
73
Bruce in the Peg