engine troubles

[Anonymous]

Live smokes only good on the larger scales and outdoors. I would just open thast bad boy up and snip the wires to the smoke generator, no need for it.

[cacole]

That's typical of the Bachmann mogul smoke generator because it is nothing but a heating element, so the faster you run the engine, the hotter the smoke fluid gets, until it starts splattering out because it is too hot. Forget about the smoke and run it without fluid. Smoke fluid just leaves an oily film on everything, anyway, and results in more need for track cleaning.

[Anonymous]

a new problem has just come up..i got new fluid...and now it just spurts the fluid out of the top in little droplets and it splashes onto the engine and track...it is starting not to smoke but instead spurt the fluid out in little droplets. what the heck is up with this engine? its not even a month old.

[Anonymous]

bachmann made it..its a 2-6-0...not too expensive yet not to cheap...runs pretty well. but dosen't smoke well.

[mcouvillion]

4664challenger,

What make of Mogul is it? A Bachmann? The smoke generators are pretty simple. Check that the tube in the center of the smoke generator is centered in the generator and vertical. It should almost touch the bottom of the fluid reservoir. The wires should touch the two halves of the frame. Use a good smoke liquid. That's about it. A little more detail from you would help the forum's members help you.

Mark C.

[Anonymous]

i bought a mogul...and it dosen't smoke like it is supposed to. it will puff for a few seconds then it will stop for a mnute..then it will puff for a fewe more seconds then stop. would better fluiid be in place of somethin?