Have some with lights installed. Want to use on Athearn BB locos. Can not find anywhere the power hook-up schematic. Any one know how to hook this up to a dc analog loco (pins 1 thru 8). I will see if I can get a photo up. thanks
I found it. Just use a standard ddc 8 pin decoder and go backwards.
Wiring a decoder into an Athearn blue box loco is quite easy. The biggest thing is to isolate the motor from the frame. This can be easily accomplished. It sounds harder than it really is. Remove the motor from the frame. Remove the two fingers that stick down from the strip on the bottom of the bottom or at least push them back up into the strip so they can't touch the bottom of the motor well. Solder a short length of small gauge wire to the bottom strip. The wire should be at least long enough to reach one inch above the top of the motor. I usually make it about two inches above the top of the motor. Cut two thin strips of electrical tape that will fit in the shiny part of the motor well so there's two layers of tape there. Secure the motor back into the frame.
Dr. Frankendiesel aka Scott Running BearSpace Mouse for president!15 year veteran fire fighterCollector of Apple //e'sRunning Bear EnterprisesHistory Channel Club life member.beatus homo qui invenit sapientiam