Trains.com

New Acela trains

3660 views
14 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    July 2006
  • 9,610 posts
Posted by schlimm on Tuesday, July 8, 2014 11:36 AM

Buslist
From FRA's High Speed Passenger Rail Safety Strategy Novemember 2009 page 17, part 2b. "FRA's regulations for Tier II operations ... Requires that the power cars at the ends of the train exclude passengers". However Tier II covers up to 150 MPH FRA notes the possibility of using higher speed EMU sets that might include occupied end vehicles. 

So it says it right there:

"New standards or guidelines could also address circumstances under which the use of 
passenger‐occupied lead units may or may not be acceptable.  FRA=s regulations for Tier II 
operations, which covers passenger trains that operate up to 150 mph, requires that the 
power cars at the ends of the train exclude passengers.  This is the current arrangement of 
the Acela trainset on the Northeast Corridor.  One HSR operation that will be constructed 
on a dedicated right‐of‐way has proposed a 150 mph service with passenger seating in the 
power cars (cab cars).  Another HSR operation has proposed a 220 mph service and has 
also included passenger seating in the power cars (cab cars). 
 
FRA realizes that some of the more modern HSR train sets used overseas eliminate the 
conventional power car and use an electrical multiple‐unit configuration that includes 
passenger seating in the cab car.  However, there are no simple answers to the question of 
whether passenger seating in cab cars is appropriate.  The answer will require careful 
research and full consideration of the operating environment where the trainset operates.  
Protection for the operator and passengers will remain a key factor."

1.  Amtrak's fleet exec. wouldn't be considering EMUs if they were not permitted.  

2.  The Acela IIs are supposed to have a top speed greater than the current 150 mph.

C&NW, CA&E, MILW, CGW and IC fan

  • Member since
    November 2013
  • 1,097 posts
Posted by Buslist on Tuesday, July 8, 2014 10:01 AM
From FRA's High Speed Passenger Rail Safety Strategy Novemember 2009 page 17, part 2b. "FRA's regulations for Tier II operations ... Requires that the power cars at the ends of the train exclude passengers". However Tier II covers up to 150 MPH FRA notes the possibility of using higher speed EMU sets that might include occupied end vehicles. FRA goes on to state that "there are no simple answers to the question of whether passenger seating in cab cars is appropriate. The answer will require careful research and full consideration of the operating environment where the transit operates." There is no record in the FRA searchable data base indicating that Amtrak has been given a waiver from the Tier II requirement. The Amtrak press release says they are looking to add 40% more seats to the new train sets. That ain't going to happen holding the train length constant and putting people in the end cars.
  • Member since
    July 2006
  • 9,610 posts
Posted by schlimm on Tuesday, July 8, 2014 9:34 AM

blue streak 1

Schlimm:  was looking at the table.  Missed it the first time around  (  figure 22 is obsolete  )

What table are you referring to?   You referred to the inaccuracies of the article in Forbes.

C&NW, CA&E, MILW, CGW and IC fan

  • Member since
    December 2007
  • From: Georgia USA SW of Atlanta
  • 11,919 posts
Posted by blue streak 1 on Tuesday, July 8, 2014 9:24 AM

Schlimm:  was looking at the table.  Missed it the first time around  (  figure 22 is obsolete  )

  • Member since
    July 2006
  • 9,610 posts
Posted by schlimm on Tuesday, July 8, 2014 8:58 AM

"Forbes has an article about new Acela orders but with several  items no longer effective.  Most glaring one is statement that Amtrak might buy additional cars for the present Acella1s.    Leave to others to find more misinformation."

The article is an interview with Mr. Yachmetz, Amtrak's guy in charge of fleets.  Are you sure you read the same article?  It does not say anything about adding cars for the current Acelas.

"Amtrak is also looking to add approximately 120 seats to the new Acela model, but without increasing the 205 meter overall length of the trainset. Amtrak will accomplish this by moving from “concentrated power” to “distributed power.” Essentially, this would eliminate the leading and trailing engines of each trainset, and replace them cars capable of carrying passengers. With this model, each car produces power individually, much like a subway train. This enables the train to carry additional passengers while not increasing the overall length. The train will still have the styled front and back cars for aerodynamic reasons, but there will no longer be dedicated engine cars."

This is what I suggested earlier, but someone claimed this design is not allowed under FRA rules.  That contention appears to be false.

C&NW, CA&E, MILW, CGW and IC fan

  • Member since
    December 2007
  • From: Georgia USA SW of Atlanta
  • 11,919 posts
Posted by blue streak 1 on Tuesday, July 8, 2014 8:44 AM

Forbes has an article about new Acela orders but with several  items no longer effective.  Most glaring one is statement that Amtrak might buy additional cars for the present Acella1s.  Another is plans for disposition of 1s as none have been announced.  Leave to others to find more misinformation.  

  

http://www.forbes.com/sites/jasonrabinowitz/2014/07/08/taking-past-lessons-learned-amtrak-designs-the-next-acela/

  • Member since
    December 2007
  • From: Georgia USA SW of Atlanta
  • 11,919 posts
Posted by blue streak 1 on Monday, July 7, 2014 9:58 AM

Disposition of Acela-1s  ? 

1.  As soon as 6 or so Acela 2s are unconditionally accepted then additional trips can be scheduled.

2.  Since BOS - NYP is running very full now expect them to start there replacing Acela-1s on those trains ? Then the replaced 1s can operate more NYP - WASH.  If the problem of the limitation of 39 trains  on BOS = New Haven can be resolved maybe even more trips there ?

3.  The lower capacity 1s can be scheduled on trains that have a lower booking.  Also as the en route times on  NYP - WASH comes down the smaller capacity 1s can be used for super expresses further reducing en route times ?

4.  It all depends on future passenger wishes that cannot be predicted now. Look at France .

5.  Good back up in case some problem with -2s occurs.

 

 

  • Member since
    June 2010
  • 78 posts
Posted by Alan F on Friday, July 4, 2014 9:19 AM

[quote user="blue streak 1"]

Has anyone found a link to the actual RFP ?

[/quote]
There are numerous documents, amendments, question responses from the joint procurement attempt still available on the CHSRA website here. The new RFP from Amtrak should be pretty close to the Amtrak part of the joint RFP for the specs and requirements.
  • Member since
    June 2010
  • 78 posts
Posted by Alan F on Thursday, July 3, 2014 11:22 PM

[quote user="schlimm"]

It says Amtrak wants to increase capacity from 304 to 420.   If they simply used a more modern design such as the Siemens-Bombardier (Class 407) Velaro D with eight EMU cars, instead of Acela's two non-passenger locomotives plus 6 coaches, they could carry 460 passengers.

[/quote]
In the spec in the joint RFP with CHSRA, Amtrak was looking for a nominal 425 seats. No reason to think that has changed in the new RFP. If the bidder offers a trainset with 450 total seats, that is a plus for their proposal.
Many documents from the joint RFP were posted on the Amtrak procurement portal and the CHSRA website. This time, there are no new documents so far on the Amtrak procurement portal RFP listing. Since Amtrak knows who the potential qualified bidders are, it appears that the documents are being sent directly to them. Again, there is no reason to expect there have been any major changes in the new RFP except to strip out all the CHSRA requirements and material.
The new bids are due on October 1, 2014 so Amtrak is turning around pretty quickly from the decision to break up on the joint order with the CHSRA.
  • Member since
    March 2005
  • From: Brewster, NY
  • 648 posts
Posted by Dutchrailnut on Thursday, July 3, 2014 9:28 PM
A RFP is not a bid, its a request for Proposal. in other words its asking manufacturers what have you got that we might want, send us your proposal. in railroad terms it means nothing...
  • Member since
    November 2013
  • 1,097 posts
Posted by Buslist on Thursday, July 3, 2014 9:22 PM
By schlimm
on July 3, 2014
It says Amtrak wants to increase capacity from 304 to 420. If they simply used a more modern design such as the Siemens-Bombardier (Class 407) Velaro D with eight EMU cars, instead of Acela's two non-passenger locomotives plus 6 coaches, they could carry 460 passengers.

IIRC FRA regs prohibit passengers in the lead vehicle on HSR operations, anyone know for sure?
  • Member since
    December 2007
  • From: Georgia USA SW of Atlanta
  • 11,919 posts
Posted by blue streak 1 on Thursday, July 3, 2014 7:50 PM

Has anyone found a link to the actual RFP ?

  • Member since
    July 2006
  • 9,610 posts
Posted by schlimm on Thursday, July 3, 2014 6:14 PM

It says Amtrak wants to increase capacity from 304 to 420.   If they simply used a more modern design such as the Siemens-Bombardier (Class 407) Velaro D with eight EMU cars, instead of Acela's two non-passenger locomotives plus 6 coaches, they could carry 460 passengers.

C&NW, CA&E, MILW, CGW and IC fan

  • Member since
    May 2013
  • 3,231 posts
Posted by NorthWest on Thursday, July 3, 2014 4:30 PM

I suspect this is the individual order after cancelling the joint order with California High Speed Rail.

Join our Community!

Our community is FREE to join. To participate you must either login or register for an account.

Search the Community

Newsletter Sign-Up

By signing up you may also receive occasional reader surveys and special offers from Trains magazine.Please view our privacy policy