Login
or
Register
Subscriber & Member Login
Login, or register today to interact in our online community, comment on articles, receive our newsletter, manage your account online and more!
Login
Register
Home
»
Model Railroader
»
Forums
»
General Discussion (Model Railroader)
»
Athearn SD70's
Athearn SD70's
1076 views
9 replies
Order Ascending
Order Descending
Anonymous
Member since
April 2003
305,205 posts
Posted by
Anonymous
on Thursday, January 16, 2003 7:49 AM
I put these together about a year and a half ago so I might be a little rusty on the specifics. I use the grain of wheat light bulbs and a 450 ohm resister in line with each bulb. I played around with the resistors until I got the right level of brilliance that I wanted before soldering everything in place. The Soundtrax and Digitrax decoders put out 12 volts DC on the lamp leads which will make a flash bulb out of your grain of wheats if you don't use the resistor.
In the operator manual, diesel edition, of the Soundtrax you will find specific CV settings to make the ditch lights operate with the horn function.
Ken, D&J Railroad, Stafford, VA
Reply
Edit
Anonymous
Member since
April 2003
305,205 posts
Posted by
Anonymous
on Thursday, January 16, 2003 7:15 AM
How did you get the lights working? I keep on burning out the bulbs, and can't seem to get the fix right.
S Oehme
Reply
Edit
Anonymous
Member since
April 2003
305,205 posts
Posted by
Anonymous
on Friday, January 10, 2003 2:47 PM
I had some problems like that while expanding the D&J Railroad. It turned out to be unlevel track. In a short section of track one rail was a little higher than the other due to splintering of the plywood under the road bed. The trucks on the SD70s don't seem to tilt from side to side as much as other models so when one rail is high, the wheel lifts off the the other rail.
Ken, D&J Railroad, Stafford, VA
Reply
Edit
Anonymous
Member since
April 2003
305,205 posts
Posted by
Anonymous
on Friday, January 10, 2003 2:40 PM
I have three of them. I installed a SoundTrax decoder in one of them with one speaker and programmed up the alternating ditch lights that activate with the horn action. They run great on the D&J Railroad and look good hauling a mile long TOFC/COFC train.
Ken, D&J Railroad, Stafford, VA
Reply
Edit
csxns
Member since
September 2002
From: North Carolina
1,905 posts
Posted by
csxns
on Friday, January 3, 2003 9:04 PM
Got 30 of them more comming.If you have 2 main lines each one with different power packs DC and going fron one line to the other they will go crazy.Atlas Kato Proto 2000 do a lot better.
Russell
Reply
highballer1
Member since
January 2002
8 posts
Posted by
highballer1
on Friday, January 3, 2003 5:35 PM
Highballer - Jim
I have four of them, and I guess I've got some track problems. As each one of them derails at approximately the very same points on my layout. All of the other six and four axle diesels I have do just fine at these same troublesome spots.
Any one have any ideas why this might be occuring?? I've looked and looked it all over and can't seem to find the source and have checked everything with the NMRA track gauge.
Also, anyone have any ideas about how much weight should be added to these SD70M's? Thanks.
Reply
Anonymous
Member since
April 2003
305,205 posts
Posted by
Anonymous
on Friday, December 20, 2002 10:22 AM
I have one. It runs well but has a small buzz noise. I think it must be something loose or rubbing that I have not yet located. They are really nice.
Reply
Edit
Anonymous
Member since
April 2003
305,205 posts
Posted by
Anonymous
on Thursday, December 19, 2002 3:47 PM
I have several of these locos. They run VERY well--are comparable to Kato or Atlas. The only caveat is that if you are running DCC, it is a little harder (not much however) to convert them than it is to convert the Kato or Atlas. In general I am very happy with these locos.
Reply
Edit
Martin4
Member since
December 2001
From: Quebec City, CA
262 posts
Posted by
Martin4
on Wednesday, December 18, 2002 10:27 PM
Hi Aaron
I got two of them (SD 75i and SD 75M) a couple of months ago; they are real wonders !
They can crawl as soon as they get over one volt and run at realistic speed at full throttle. Their details is unbelievable; everything looks to scale. I also have many Katos and P2000s that do not quite match the look and performance of the Genesis'. Go and get them !.
Martin
Reply
Anonymous
Member since
April 2003
305,205 posts
Athearn SD70's
Posted by
Anonymous
on Wednesday, December 18, 2002 9:31 AM
I need info. on how the Athearn Genesis SD70's run. I heard they run pretty good and I want to purchase 2 of them for my model railroad.
Thanks for your help,
Aaron
Reply
Edit
Subscriber & Member Login
Login, or register today to interact in our online community, comment on articles, receive our newsletter, manage your account online and more!
Login
Register
Users Online
There are no community member online
Search the Community
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT
Model Railroader Newsletter
See all
Sign up for our FREE e-newsletter
and get model railroad news in your inbox!
Sign up