plastic building corners

[Anonymous]

TMan,
I've searched using the search function at the top left of the page.
Where it says "Entire Site" and has a drop down button, you can choose "Forum" to limit the search here.
Eric from Doylestown

[Anonymous]

How does one access past posts?

[CNJ831]

This subject was addressed in some detail not more than a month ago. Take a look back under earlier posts.

John

[mhdishere]

If the sheet is thin you may be better off overlaying one sheet with the other. If you really need the bevel try this: Get a 45 degree angle, like the square/angle part of a combination square. Place one edge down on the work surface, attach a piece of sandpaper to the work surface, and hold the sheet against the angle and sandpaper and sand to a 45. I havn't tried this myself, but I've done something similar to get a 90 on thick kit building walls.

Hope this helps!

[Anonymous]

How does one make a 45 degree angle cut lengthwise along the edge of a plastic sheet for forming corner joints on model structures?