Atlas #304 Roundtable Motor

[Anonymous]

Mike, Thanks very much. Your suggestion worked like a charm. I now have a working roundtable!! Thanks again, John

[Anonymous]

Mike, Thanks. I'll try it and let you know if it works. Sounds like it will.

Regards, John

[Anonymous]

Change the supply voltage to 5v DC. I run mine on an old power pack and use the throttle to control the speed of the motor.
Mike

[Anonymous]

I recently got my roundtable and motor operator installed on my layout but am having problems. I tried it out when I got it a few months back and everything worked fine. Now that I have it installed it doesn't seem to work. It seem that the shaft is turning but the the rest just sits there. Should I change the rubberband or do something different. I'm not sure what the voltage should be either. At present I'm using aprx. 17vAC. I lost the instructions somewhere in my menagerie of paperwork and don't know what else to do. Any help or information will be kindly accepted and tried. John