Mike to make a click linkable, that is not on the Trains or MR website, use the chain icon link.
https://tcsdcc.com/installation/ho-scale/1384
For MR links, I've gotten lazy and use the Tiny.url add on or extension (depending on your browser. That copyies the link in to a shorter HTML address
https://tinyurl.com/ybqvkhp
The other option is to type (using brackets, not parenthesis) and don't use the link icon.
(url)http://cs.trains.com/mrr/f/88/p/283017/3255189.aspx#3255189(/url)
http://cs.trains.com/mrr/f/88/p/283017/3255189.aspx#3255189
That usually, but not always works. Editing the post can somehow break the link
Henry
COB Potomac & Northern
Shenandoah Valley
Thanks for all the suggestions. I'll report on the results when I get the time to work on it again.
If this model is an P2K FB-1:
http://www.rrpicturearchives.net/showPicture.aspx?id=3022389
The trick is that you have to remove the plastic fuel tank. It's only held on by friction, so it should come off pretty easy. You do have to watch the slack adjusters on the truck sideframes, but the tank should come off with some wiggling around. Under the plastic tank, you'll see four Phillips head screws in the corners. Remove all four, and the shell will lift off (no other tabs). When putting it back on, watch out for the corner stirrup steps on the rear (the fan end). They tend to hang up on both the large weight and then the frame. A little nudge with a screw driver will get them past.
If it is an P2K FB-2:
https://dieselshop.us/Burst-9.HTMLYou don't have to remove the tank. You'll see the 4 screws around the outside of the tank and just do the same as above.
As others have said it should be a case of easing the sides above the fuel tank and it should just slip off, however, sometimes those shells can sit at a bit of a slant and may for that reason - or some other- have had a bit of glue added to tighten things up. In that case something very thin between the frame and the body and feel gently for any such thing.
I have a vague memory of a B unit that had a tab protruding from the end of the frame just where the diaphragm is. Same drill in this case.
Llenroc fan It's HO and I'm not certain which release as I just picked it up used. I tried the widening the shell technique and that did not seem to work at all.
It's HO and I'm not certain which release as I just picked it up used. I tried the widening the shell technique and that did not seem to work at all.
What model?
Gary
Are you sure it is Life Like?
Some other manufacturers have screws from the bottom to hold the shell on.
GARRY
HEARTLAND DIVISION, CB&Q RR
EVERYWHERE LOST; WE HUSTLE OUR CABOOSE FOR YOU
Llenroc fan I need to remove the shell from a Life Like B unit to lubricate it and possibly add flywheels. Any references for YouTube videos, etc. would be appreciated. Thanks.
I need to remove the shell from a Life Like B unit to lubricate it and possibly add flywheels. Any references for YouTube videos, etc. would be appreciated.
Thanks.
What B unit? That is, what model, what scale?
If, say, a Proto 1000 F3B, just getting your fingernails under the shell near the fuel tank and widening it should work...