Joe, yes, you are correct. I would need version 9 firmware. My version is 8 and does not come with the different things you can do with the bell. Too bad. I think the only way to correct this is to replace the old decoder with a newer one, maybe from Soundtraxx. Thanks for the information.
I don't think it's possible unless you have version 9 firmware. Pages 134-137 of their manual talks about the bell. Joe
http://qsindustries.com/manuals/full%20dcc%20manual.pdf
Is anyone familiar with the QSI decoder for the Athearn Gas Turbine? I'm trying to figure out how to slow the bell rate using JMRI. I cannot find any information on the QSI decoder info that allows you to adjust the bell rate. It rings way too fast for what I think it should for the prototype. Is there a standard CV that will allow you to do this?
Thanks for reading.
JRP