Is it possible to install a LokSound Select decoder in a BLI Locomotive? I even tried searching BLI website in the manuals and can't if these engines bring the 8 pins connector to install the LokSound decoder.
Thank you.
The BLI Blueline Diesel Operators Manual shows an 8 pin connector. Are you installing DCC in a DC loco or are you replacing a DCC decoder?
Henry
COB Potomac & Northern
Shenandoah Valley
Hi,
I've replaced the BLI decoder in several steam and diesels from Broadway Limited.
All their internal wiring is black or gray insulation so you have to "ring-out" the wiring scheme. I've done QSI and Paragon 2 decoders this way. It is pretty straightforward once you sort things out.
Here's an F7 A unit, for instance:
Broadway F7 Decoder by Edmund, on Flickr
Don't forget a resistor for the headlight since the light output voltage is 12-13 volts on a Loksound decoder and the Paragon decoder has the resistor on the board.
Here's a recent RS-15 I converted:
BLI_BLE_RS15dcc by Edmund, on Flickr
And if you're looking at steam this is pretty much what you'll find in the tender:
IMG_6416_fix by Edmund, on Flickr
Hope that helps,
Do you have a particular BLI engine in mind for your conversion?
Good Luck, Ed