I hopen the OP posts a picture of what he is looking for.
.
From the decription, I have no idea what this thread is about.
-Kevin
Living the dream.
rrinkerWithout that information, or a visual on the resistor, it's going to be hard figuring anything out short of testing to destruction.
It dawned on me that maybe the OP is calling the Light Emitting Diode a resistor?
mandprrthree lites wwith Plastic shield for each resistor
"Plastic shield" being the visor over the signal lens, maybe.? Some of my Oregon and NJI signals came with 1.2mm axial LEDs.
Today, of course, you can get 0402 LEDs pre-wired that would fit into just about any N scale housing. I just put some into a PRR dwarf and it was like microsurgery — but it works!
PRR_PL1 by Edmund, on Flickr
That's an HO Kadee #5 in my fingers.
Perhaps the OP is looking for raw LEDs?
Good Luck, Ed
hey, those pictures are actual size - for Z scale!
NJ International is certainly a US company.
The description is odd. LED signal with plastic shield for resistors. I would hope that if they cover the resistors with heat shrink or some other sort of enclosure where you can't see the value, they would then tell you either the value of the resistor, or the voltage they are designed to work on.Without that information, or a visual on the resistor, it's going to be hard figuring anything out short of testing to destruction.
--Randy
Modeling the Reading Railroad in the 1950's
Visit my web site at www.readingeastpenn.com for construction updates, DCC Info, and more.
peahrensAre these available for us?
Or for the U.S.?
Henry
COB Potomac & Northern
Shenandoah Valley
Are these available for us?
[/quote]
Nor at all clear what you are asking. What are "these" that you refer to? Resistors, plastic covering of bare wiring, etc? And/or, what is your concern?
Paul
Modeling HO with a transition era UP bent
We are getting warm. But, NJ International's website is terrible. Entries on their left side menu bar are dead ends. This is the picture they show for the Nscale dwarf signal and they would have been hard pressed to have a smaller picture.
Since you bought the signals and they have resistors, we still aren't clear what you are asking.
Nscale dwarf signal made by nj- three lites wwith Plastic shield for each resistor
mandprr Recently bought an nscale dwarf signal and resistors we’re protected by plastic cover. Are these available for us?
Recently bought an nscale dwarf signal and resistors we’re protected by plastic cover. Are these available for us?
Ebay is full of resistors, if that is what you are asking.
If you are asking about a plastic cover for the resistors, no one is going to know since you haven't told us who manufactured the signals and resistor "protectors" haven't been discussed that I know of.