Hello all
I have a Loksound select v3.5 installed in a Kato SD70, HO...
Doesn't seem to be working right.
The function buttons not behaving
Tried to reset programming cv8 to a value of 8, no change?
Is there another way to reset decoder?
I'm using a Digitrax dsc100, dt 400 throttle.
I have a few 3.5v decoders and used CV8 method, But, cycle track power and about six seconds later the headlight will flash a number of times for a successful reset. Loco runs on address 3.
I use a NCE Power Cab.
I have seen a few times in a forum that some clip a 1k resistor across the rails when using a Digitrax system.
Rich
If you ever fall over in public, pick yourself up and say “sorry it’s been a while since I inhabited a body.” And just walk away.
You may be trying to make the 'wrong' decoder reset...by using an address the decoder no longer recognizes as itself.
Acquire Address "00" on your DT400 and enter Ops Mode programming. Then do CV8 with the value of "08" and be sure to shut off power to the tracks immediately afterward. Power the rails once more and see if you get a reset.
If that doesn't work, you need a new decoder or your DCS is not working properly. In fact, it wouldn't hurt to reset the DCS if it won't cause you a lot of grief, and then try the reset using Add "00".
Do you have a Loksound 3.5 or a Loksound Select ? There's no such thing as a Select 3.5.
Mark.
¡ uʍop ǝpısdn sı ǝɹnʇɐuƃıs ʎɯ 'dlǝɥ
Loksound Select...
Making some progress with decoder pro,
Can't seem to get the ditch lights to turn on?
They're attached to the aux 3 & 4 wires
But don't turn on at all?