By the way Rich thanks for the web site. I googled them and most places wanted between 20.00 - 30.00 for 100 plus shipping. Thanks again.
I ordered them thru Micro Fasteners, 100 for about 6.00 and 4.00 for shipping. got the brass ones for ease of soldering.
gondola1988 Thanks Guys, ordered 100 of them. You can always count on someone here on the forum to find or get answers . thanks again Jim.
Thanks Guys, ordered 100 of them. You can always count on someone here on the forum to find or get answers . thanks again Jim.
Jim,
Who did you wind up ordering from?
Rich
Alton Junction
If you want to go with an "all-Atlas" solution, you can order just the buss bars and the screws directly from Atlas.
I don't use screws to attach the wire to the buss bar - I solder that instead. But IMHO, using the buss bars to bring the wiring out to the side of the turnout makes the whole process easier.
The screws are blackened to match the frogs, and after normal weathering and ballasting the brass buss bars are just about invisible, too.
Atlas part numbers are 200001 for the screws and 200002 for the bus bars.
I use 1-72 brass, that way I can solder a feeder wire on easily. It's harder to solder to steel. I run my screws up from the bottom so nothing sticks out the top.
--Randy
Modeling the Reading Railroad in the 1950's
Visit my web site at www.readingeastpenn.com for construction updates, DCC Info, and more.
You can buy brass micro screws here in bulk at a reasonable cost:
http://www.microfasteners.com/
I'm looking for the screws for powering the frogs on Atlas # 6 turnouts, I think they are 1-72, I need about 100 of them and wanted to buy them in bulk if possible brass or steel will work. Any help would greatly helpful. Thanks Jim.