Light bulbs have different resistance when the filament is cold vs when it is hot, this is probbaly the causeof the 'surge' you see. If it's too high and burns out the bulbs, then you have too small a resistor.
470 ohm is too small for a 15ma 1.5V bulb, just about right for a 30ma 1.5V. For all esle being equal, a closer 'exact' value for a 15ma ulb is 940 ohms - but they don;t make such a resistor in common 10% tolerance types. 1K is the closest without going under - but remember there is a 10% tolerace, so that 1K can be anywhere from 900 to 1100 ohms. Likewise the smaller ones - that 470 ohm can be as low as 420 ohms which is too small and runs the bulbs with too much voltage.
--Randy
Modeling the Reading Railroad in the 1950's
Visit my web site at www.readingeastpenn.com for construction updates, DCC Info, and more.
It sounds like you don't have a proper resistor connected to your lights. I always use a 1,000 Ohm resistor regardless of Ohms law calculations with an LED or 1.5 Volt bulb and have never had any problems with them.
What is the resistor value you are using? I use a 1.5 volt bulb in a decoder equipped loco and use a 470 ohm resistor. Never noticed any flaring but the bulb is for a beacon. The voltage is around 1.1 volts at the bulb. I use a NCE power Cab at home and NCE Power Pro at the club. Both have a DCC voltage of about 13.8 volts.
Rich
If you ever fall over in public, pick yourself up and say “sorry it’s been a while since I inhabited a body.” And just walk away.
Sounds like a good question.
However, I haven't noticed any surge on start-up from my DCC system. NCE Power Pro.
Elmer.
The above is my opinion, from an active and experienced Model Railroader in N scale and HO since 1961.
(Modeling Freelance, Eastern US, HO scale, in 1962, with NCE DCC for locomotive control and a stand alone LocoNet for block detection and signals.) http://waynes-trains.com/ at home, and N scale at the Club.