Hamltnblue Does anyone make a direct replacement.? I know the problem is that sometimes they have the Head and Tail Light LED soldered on the board.
Does anyone make a direct replacement.? I know the problem is that sometimes they have the Head and Tail Light LED soldered on the board.
Not that I can find, and yes, the LEDs are on the circuit board, but the TCS install pictures show how to get around that.
The stock DC board won;t do any good, really, the OP has the DCC On-Board version so that board is a decoder. The TCS install shows one with a plain light board, but the overall location of wires and stuff should eb the same.
Edit: I take that back, I looked again and the one shown MUST be the DCC On-Board, there's too many chips on the circuit board for it to just be directional lights.
--Randy
Modeling the Reading Railroad in the 1950's
Visit my web site at www.readingeastpenn.com for construction updates, DCC Info, and more.
Springfield PA
What is the issue with the PC board other than being bad? I might have a PC board out of a 70 ton I do not need. The PC boards are rather simple.
Rich
If you ever fall over in public, pick yourself up and say “sorry it’s been a while since I inhabited a body.” And just walk away.
I don;t think anyone has a board in that form factor, so short of replacing it with another of Bachmann's rather limited decoders, you'll probably have to wire one in. Here's an example from TCS: http://www.tcsdcc.com/Customer_Content/Installation_Pictures/HO_Scale/Bachmann/Spectrum_GE70/Bachmman_Spectrum_GE_70.html I would also add that you should clip off those yeloow objects attached across the motor wires, those are rf supression capacitors and will interfere with smooth running of a better quality decoder like the TCS.
Hello,
I have a Bachmann GE 70ton Switcher which has a bad DCC board. The engine will run on DC. What would be a good replacement board for this engine since the DCC and electronics board are combined?
Thanks