Yes, that's what it's for.
--Randy
Modeling the Reading Railroad in the 1950's
Visit my web site at www.readingeastpenn.com for construction updates, DCC Info, and more.
Now Power via a wall wart is not a problem.
What about the rear rail a and rail B screws, I wonder if I can wire them into the track bus wires rail a and B to gain a lighted indication for that area?
UR91 Radio receiver comes with a PS12 power supply. Contrary to the wording in the Digitrax instructions, it should be powered by that PS12 exclusively. UR91's are drawing some power all the time to keep the radio on.
UR90 does not come with an included power supply. For best operation, it should be powered by a PS12.
Chaining additional UP5 throttle panels via the +common connection can also be done. Whether or not operations will suffer really depends on how many throttles are plugged into the UP5's. UP5's and UR90's draw little or no power when just sitting there.
Martin Myers
This begs-the-question, "Why does the power supply not come as standard with the UR90/91 if it is needed?".
One PS12 can power a number of the Digitrax panels. So if you have more than 1 wireless panel and or additional UP5 plug in panels then you don't need a PS12 for each of them, you can daisy chain the power around the layout.
My Zephyr powered layout has 3 UP5's and a UR90 all powered from a single PS12. A single wire powers them all. The instructions that come with any of the panels show where to do this.
Simon Modelling CB&Q and Wabash See my slowly evolving layout on my picturetrail site http://www.picturetrail.com/simontrains and our videos at http://www.youtube.com/user/MrCrispybake?feature=mhum
David, you seem to be right, so I'll buy the PS12 when I get the UR90.
- Luke
Modeling the Southern Pacific in the 1960's-1980's
Would it freak out if I plug 1 DT400 throttle into the UR90?
If you want it to work properly and reliably, use the PS12. The UR90 and UR91 really draw too much power from the Loconet to work reliably - if you never plug anything else in, and it's only a short connection to the Zephyr it might work fine, unless you plug in another throttle, which would likely load the Loconet down too much and result in erratic operation.
i have used the UR91 using just the power supplied by the loconet cable. it may depend on volts, loads, distance as to whether this is a good idea or not, but on my 8x4 it worked ok.
For this: http://www.digitrax.com/prd_rec_ur90.php , do I have to buy a PS12 power supply or can I use the power from a DCS50?