nce/proto s1

[locoi1sa]

  Yes the Z or N scale decoder would be a better fit. And listen to the previouse poster about ISOLATING the motor. There is more info on Toneys web site. I hardwired TCS MC2 decoders in mine with out a problem.

[tstage]

I actually have a Z-scale decoder installed in my Proto 2000 S1.  That way I didn't have to remove any of the frame to fit it under the hood.  (Not much room.)

---

WARNING:  Make sure you isolate the motor from the frame in your S1 first BEFORE you install a decoder in it.  Otherwise, the decoder will go *poof!*

---

Even though Proto 2000 says it's "DCC-ready", it really isn't.

Tom

[bn7026]

Hi,

The NCE website recommends a N12SR with a shortened harness.

NCE has a heap of decoder recommendations at the following address: 

http://www.ncedcc.com/decoder_use_list.pdf 

Regards

Tim

[mrshubbie]

I was sent a d14sr to fit my proto 2000 s1.Is this the right nce decoder for this unit?