NCE D13SR wiring

[Bapou]

I am trying to install a NCE D13SR decoder in a P1K RDC-3. In the decoder manual it says which wire does which... by color. On the RDC it shows where to connect the decoder wires... by number. Can somone post a chart which wire color would be which number?

[Bapou]

After a few hours of searching I found it on the NMRA site finally here it is for others like me:

Pin No.
Use
1
Orange
Motor Right

2
Yellow
Rear Headlight

3
(1)
 
4
Black
Left Rail

5
Gray
Motor Left

6
White
Front Headlight

7
Blue
 Common (V+)

8
Red
Right Rail
 

[Driline]

After a few hours of searching I found it on the NMRA site finally here it is for others like me:

Pin No.
Use
1
Orange
Motor Right

2
Yellow
Rear Headlight

3
(1)
 
4
Black
Left Rail

5
Gray
Motor Left

6
White
Front Headlight

7
Blue
 Common (V+)

8
Red
Right Rail
 

Bapou, although the NMRA provides a color wiring chart, its not always accurate with the decoder you are using. I found this out the hard way with a soundtraxx decoder. Always check to see where the wires are going, don't always rely on the color code. My RTR Athearn Gp PC board wiring colors were backwards. So I had to use an ohm meter to track down the actual wiring schematic.

[Bapou]

I did compare it with the manual, thanks for the warning.