For a couple days now I'm driving myself crazy trying to get an NCE Switch 8 + the Button Board to throw my Kato turnouts and a double crossover (one at a time ) on a new layout I'm in the process of building. I've done this just as a test to see if the boards work on my Kato turnouts - and one Kato double crossover. I only need to wire 3 turnouts and one double crossover for my new layout .. at least for the time being. No track laid yet ... just testing. My smaller layout that I've had for a year and a half uses Kato turnouts and a double crossover also (just two turnouts on that layout) and they're all thrown by NCE Switch Kats. All those work fine. However, I can't get this combo (NCE Switch 8 + Button Board) to throw anything. Really frustrating. I'll attach a diagram of my wiring (taken from NCE and altered to reflect my testing) so that you all might catch something I've missed. I hope it's not that the Switch 8 + Button board won't throw Kato turnouts .. but, alas, that's what I'm thinking about now.
Any help would be appreciated.
Mike
I believe that the switch8 is for stall motor turnout operators.
Are the Kato operators stall motor or solenoid?
They are solenoid .. I should have done my research before purchasing .. duh!!
I think I'll use the combo for some LED lighting ... perhaps both street lighting and interior building lighting .. I was told by Ed at NEC this morning (7/21/23) that the LED lighting would work if they're 12 volt and have transistors. So, off I go to the Internet to see what I can find .. . This time only for a few for testing. I would want to be able to turn on and off the light(s) with momentary push buttons (for running trains in a darkened or lighted garage) so I could turn on or off street lights and interior building lights depending on the brightness of the garage.
Thanks for the reply ...
1943MikeLED lighting would work if they're 12 volt and have transistors.
Did you mean resistors?