Atlas Commander pager mode programing.

[Anonymous]

I need help in programing a Digitrax DN146A with an Atlas Commander with Ver. 3.2 software. Digitrax recommends using page mode programing. I have the Atlas Page Mode Charts but the directions are minimal. I tried to follow them but got no results.

I would also like to know if there is anyway to program CV08 with the Commander to reset the digitrax decoder to factory defaults.

Thanks for any help.

[rrinker]

The DN146 does not have the decoder reset function. It is new enough that it should also program in Direct mode, as well as Paged. Digitraxs recommends Paged because it is usally faster. Not sure how the Commander works in this regard, but my Zephyr doesn't do anything noticably different (to the user) once you select a programming mode and start.

Here is a list of the supported CVs: http://www.digitrax.com/v1/dn146a.htm

--Randy