Scenery help, closing the barn after horse is out

[Anonymous]

I solved my gap problem this afternoon. I just applied some LePage No More Nails to the top surface of the incline and spread it evenly. When it dried, the surface over the gaps was quite rigid. No more gaps! I imagine you could do the same with risers.

[Anonymous]

I agree with Robert Knapp! Great Stuff expanding foam works wonders with cracks and gaps. It comes in three consistences depanding on the size of the crack. I started using it because Dave Frary used it on his Cactus Valley RR, the model I'm using for my own RR. It's a little stinky, and you have to becareful not to put too much ont the crack. It does expand quite a bit. You can then trim and shape it using a sharp knife.

Trevor[:)]

[scole100]

If your risers are on a solid plywood base, you may consider filling the gaps with some cheap childs play sand. Just pour it in between the rails. Once you fill it to the top of the riser you can just scenic the top of it. Great stuff will work, but is unpredictable in how much it will expand and is very difficult to clean up if it expands over your tracks. perhaps a combo of great stuff at the bottom sand up to the top? That way you would not have to worry about being so precise with the expanding foam.
hope that helps.

[bogp40]

Try using Great Stuff expandable foam, cover the track w/ masking tape first, any stray foam will be hard to remove. This works great even for double track spline. Put masking tape across the open bottom and slowly run a bead between the tracks-a 3/8" bead usually comes out of the tube- don't overfill it will expand up to 10x. When dry it can be carved and shaped to suit your scenery needs.
Bob K.

[Javern]

stuff newspaper in there and then go back in with putty or plaster, caulk, etc

[Anonymous]

My layout uses Woodland scenic Risers with Unitrack. "N" scale dual mainlines on the risers with about 1" in between. I have attached most all of the Unitrack to the risers. It works well, but... I didn't cover the risers with plaster cloth or anything similar first. I'm not going to pull up working track. How best to fill in the gaps between my two mainlines on the Risers ? The sides I'm not too worried about, just the middle, but I'm open to all suggestions. I tried filling the gaps with LightWeight Spackling but the gaps are too large. Should I line between the Rails with Masking tape or similar, then spackle ? Thanks, Dave

I'm a lefty I do most things Bass Ackwards :)