Trains.com

Subscriber & Member Login

Login, or register today to interact in our online community, comment on articles, receive our newsletter, manage your account online and more!

Around the walls track plans

2831 views
10 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    April 2003
  • 305,205 posts
Around the walls track plans
Posted by Anonymous on Thursday, January 20, 2005 8:12 AM
Greetings,

I am looking for relatively simple track plans for an around the walls layout -- about a 12 X 5 with 2-foot wide shelves. I've started with a double track oval with the outer loop hidden about half its length. I want the double track so that the kids can run a train while I operate but I don't want to show too much track -- sort of like the track-to-scenary ratio typically found in Narrow Gauge and Short Line Gazzette. I know this is not a common mix of requirements but it meets both of my criteria. In any case, most plans I see look like bowls of pasta or something nearly suitable for a club layout. Your suggestions are appreciated.

Thanks,

Rod [:p]
  • Member since
    April 2003
  • 305,205 posts
Posted by Anonymous on Thursday, January 20, 2005 8:58 AM
Just to clarify...

A 12 x 5 around the walls layout with 2 foot wide shelves will only leave a 1 foot wide aisle in the center. Is there a typo there?

John
  • Member since
    July 2004
  • 785 posts
Posted by Leon Silverman on Thursday, January 20, 2005 9:03 AM
If your room is truely 12 x 5, then you will have to make your shelves 18" or 12'' wide r) at the most. Two foot wide shelves in a five foot room leave an isle width of only one foot. This is too narrow for most adults. A two foot wide isle would still it difficult for two adults to squeeze by one another without doing damage to your layout or trains if theywere near the edge.
  • Member since
    April 2003
  • 305,205 posts
Posted by Anonymous on Thursday, January 20, 2005 9:14 AM
Point taken -- I think I'm off in my estimate because there is a lot of room to move around inside the rectangle of tables. In fact, I probably have too much space given up inside the circle but I built the tables to fit the walls of a prior house and then moved them into a room in my newer house, putting the end tables outside the longer tables rather than on the inner edge (admittedly hard to visualize without a diagram). In any case, its a pretty good sized oval (maybe I'll measure it tonight so I get it right) and I just want some ideas on the best places to put yards and sidings. Thanks for the responses.
  • Member since
    August 2003
  • From: Midtown Sacramento
  • 3,340 posts
Posted by Jetrock on Thursday, January 20, 2005 11:07 AM
You're right, it is pretty hard to visualize--dimensions or a diagram would be very helpful.
  • Member since
    July 2002
  • 12 posts
Posted by Scholten on Thursday, January 20, 2005 11:54 AM
As you asked about ideas for yards, let me share some thoughts about the N scale shelf layout I am designing. I plan to build a 2-foot wide shelf around three walls of an alcove in the basement. The lengths of the sides will be about 15', 14', and 9'. The original plan was to put a large yard at one end of this uneven "U", but I now think the yard will go in the middle section. This will allow trains to set out in two different directions, providing more operational interest.

Good luck with your project!

Paul Scholten

  • Member since
    April 2003
  • 305,205 posts
Posted by Anonymous on Thursday, January 20, 2005 5:24 PM
Well my plan:
2 one foot wide shelfs going around a room that is roughly 14'x15', one on top, 1 on bottom. The top will be the mainline and a few industries. The bottom, 2 staging yards, and a short line. I am open for ideas if anyone wants to post...

Morgan
  • Member since
    August 2004
  • 2,844 posts
Posted by dinwitty on Thursday, January 20, 2005 7:59 PM
I have turned away from tables to Shelf mounted modules, removeable for upclose work. The shelf average width is 18 inches. Sticking with prototypical operation.
not too much room for structures, likely get kitbashed against the wall.

  • Member since
    April 2003
  • 305,205 posts
Posted by Anonymous on Thursday, January 20, 2005 8:14 PM
I have my HO around the wall layout in an old garage that I want to replace with a new steel shed 12' wide X 15.5' long. Q: I want to retain a couple of shelves - 2.5' wide X 12' long. Do you suggest mountining existing adjustable height legs on hinges onto shelves, fold & store while new shed built. Then unfold legs & instal stays. I would rebuild the other 2 shelves. Hugh.
  • Member since
    April 2003
  • 305,205 posts
Posted by Anonymous on Thursday, January 20, 2005 9:01 PM
Hugh again, the length of shed will be 17.4'. It is actually a shed 17.5' L X 20' Wide. Part will be my workshop but train part will be 12' width X 17.5' length. I live in Melbourne, Australia & we dont have basements. I do not like 2 tiered layouts as I 'cannot ' climb after a stroke that I recoverd 97% +; well the boss claims I dont climb. You just ask her!

Hugh
  • Member since
    January 2005
  • From: ARCH CITY
  • 1,769 posts
Posted by tomkat-13 on Thursday, January 20, 2005 9:16 PM

http://home.mindspring.com/~kat15/club1.jpg



This is a 30 inch by 6 foot area......as you can see there is room for both track and scenery.... I think that arround the wall is the way to go......sometime less is more!....also you should weather all your rolling stock and buildings.....this helps by making things blend together and tie everything together......good luck.....
I model MKT & CB&Q in Missouri. A MUST SEE LINK: Great photographs from glassplate negatives of St Louis 1914-1917!!!! http://www.usgennet.org/usa/mo/county/stlouis/kempland/glassplate.htm Boeing Employee RR Club-St Louis http://www.berrc-stl.com/

Subscriber & Member Login

Login, or register today to interact in our online community, comment on articles, receive our newsletter, manage your account online and more!

Users Online

There are no community member online

Search the Community

ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT
Model Railroader Newsletter See all
Sign up for our FREE e-newsletter and get model railroad news in your inbox!