converting manualy operated switches to automaticly operated switches

[Anonymous]

Iv'e been using Tortoise switch machines for years and I love 'em. If you ask me, I'd use Tortoise. They are not only quiet, but gentle. Like was said earlier, some switch machines can damage turnouts over time. I have had to drill holes for the switch machine linkages with the turnout in place, but you have to be careful. Just drill down between the switch points and ties. If you can remove the turnouts, it would be easier.

[cwclark]

I just installed some tortoise machines and they were the easiest under the table switch machines i've ever installed...but to answer your question..you are going to have to remove the turnouts to drill holes under the layout that match the throwbar with any under the table switch machine you prefer...or....if you are using Atlas turnouts you can purchase there twin coil turnout machines and mount them in place of the manual turnout throws...you'll need an atlas push / slide switch and also an atlas relay if you want to run signaling targets or control panel lights....

[cacole]

What brand turnouts are you using? If they are ones that you can easily reach to throw by hand, you can use Caboose Industries ground throws instead of electrically powering them. If they are out of reach and need to be powered, your best bet would be to use Tortoise or SwitchMaster stall-motor switch machines. Twin coil switch machines are cheaper, but damage turnouts over a long period of time with their violent action.

[Anonymous]

I was laying some track when i realized i might be making an awful mistake. I noticed that all the switches i layed are manualy operated. there is no way i can operat this railroad if i have to run around flipping switches all the time. Is there some kinda electro magnet i can set up to make my switches automatic. or am i in trouble?