question on wiring up for DCC on N scale

[Anonymous]

I am up to the wiring stage on my N scale layout. I would like to go with DCC but at the moment I find it a little difficult for the cost wise for the initial packs etc.
Meanwhile, I figure that I could wire every thing up ready for when I can afford to buy. Can anyone advise me as to the best way to go about this prewiring stage.

[Anonymous]

Hello, wire with your 2 bus lines to with drops every 3 feet or so, you can run trains with your DC power pack till you can get the DCC stuff, buy the book EASY WIRING pfr DCC

[dano99a]

Wire it with blocks and DPDT switches so while using DC you can control movements throughout the layout. And I would follow the direction from "pacificnorthern" put drop feeder wires about 3 ft. apart.

When you convert to DCC just connect all the feeder wires to the two wires that go into the DCC command station. Should take you about 5 minutes to convert it.