Hum, a Bubble Head? I work with a X Bubble Head, he is not just right But, neither am I, X 18th Air Born.
Cuda Ken
I hate Rust
Bob D As long as you surface as many times as you dive you`ll be alive to read these posts.
Jay
C-415 Build: https://imageshack.com/a/tShC/1
Other builds: https://imageshack.com/my/albums
What you are talking about was written up in MR some years back. The contours were cut by a foam hot wire cutter. The wire inserts were bent to shape the roadbed and the ditches all at the same time. The problem that I saw was that you either had to have a very steady hand, or use something that the tool could ride on so you didn't end up with a wavy roadbed.
It is a nice concept, but I decided to go with WS foam roadbed and open up the ditches with a hot wire cutter if I had to.
Elmer.
The above is my opinion, from an active and experienced Model Railroader in N scale and HO since 1961.
(Modeling Freelance, Eastern US, HO scale, in 1962, with NCE DCC for locomotive control and a stand alone LocoNet for block detection and signals.) http://waynes-trains.com/ at home, and N scale at the Club.
I use 1.75, inch foam for the base on my new section. I still use cork roadbed to support the track. Cutting the foam perfectly level if there are any grades will be a little tuff. Cork roadbed will help will in the little dips that will show up.
After I get my roadbed down using latex caulk, I sand with an 8" sanding block to help level out the dips. I use 36 to 80 grit sand, paper.
Greetings Sub Man,
I would take a index card sized piece of thin wood like paneling and cut out a jig from that.
You can test your heights, and wideths as you go along, you have got a lot of very messy work ahead of you that is for sure, have a shop vac handy and good luck, your idea is very interesting and I'd like to hear about the problems and advantages you had in the making of this road bed.
Happy Rails, Jess Red Horse.
I have one area on my layout that I used foam to transition from one level to another. It's a mountain road. I used a power sander to cut in the rough shape and followed that up with a hand sanding block.
Marlon
See pictures of the Clinton-Golden Valley RR