Tried that, did not work. Guess I'll try the shop tomorrow.
Thanks again for the help.
Yes, all of the above are correct, just like the manual says.
I have a DC powerpack that I switched it over to and everything is fine, loco runs all the way around, forward and reverse.
Can't figure out why the DCC won't work.
Thanks for the reply!
Getting back into this after 25 years, been lurking for awhile, collecting parts, designing a layout, etc.
Handed over the box of stuff for xmas today. I have a basic layout setup, just a loop to test connections, etc. Doing benchwork on the rest of the room, except now the secret is out that it is not a woodworking bench but a train bench.
Have a Digitrax Zephyr DCC system and a non DCC Atlas loco. I think i have everything connected properly, but the loco doesn't move. Light is on, it "sings", track has power, track is new, loco is new so I think the connection is new. Everything sets up like the quick start guide says, brief CS, set loco to "00".
Cannot get it to move, so I disconnected and played with a few things. Only difference now is upon startup I do not get a brief CS code, but SLP.
ANy help is appreciated.