Please Help First Time RC Installation

1060 views

1 replies

pimanjc

Member since
September 2003
262 posts

Posted by pimanjc on Friday, October 30, 2009 6:01 PM

Which [RCS] ESC-throttle are you using? I have installed an RCS BELTROL system into an F3AB unit using the RCS 9A ESC and Spectrum DX5e. You might check this web site for wiring diagrams:

http://www.beltrol-rc.com/index.php?page_id=1159

http://www.beltrol-rc.com/index.php?page_id=1332 .

...and this thread:

http://www.mylargescale.com/Community/Forums/tabid/56/aff/35/aft/111792/afv/topic/Default.aspx

JimC

"Never promise more than you can give. Always give more than you promise." ~JC "You don't stop laughing because you grow old, You grow old because you stop laughing." ~AU

Reply

BruceCarter

Member since
October 2009
1 posts

Please Help First Time RC Installation

Posted by BruceCarter on Thursday, October 29, 2009 4:23 PM

I am trying to install Radio Control System in a box car and am stuck with where to connect what. I have the SPEKTRUM DX5e system and cannot get it to run my loco in both directions. It will run in only one direction. Could some one please help me with this problem. A wiring diagram would be good if at all possible. The loco i am tring to setup this up on is:-

Aristo-craft U25C.