Need help with new Airwire decoder

[Run the Town]

Hi everyone, i am making a battery car that holds the battery and also an airwire decoder AWD10SS.  How do I program that decoder to read or recieve my 9000T throttle commands?  Any help will be appreciated.  Barry

[sawdust]

Hi Barry,  You must not have the booklets that come with the Airwire products for they are very plain and easy to use.  I have 4 steam locos on AirWire with Phoenix P-5 sound and can only 3 at a time due to the size of my garden but capable of all four with the T9000 throttle.       Set the decoder with a frequency for that loco, then program the T9000 for that decoder, a simple and short step.  This allow you to jump back and forth between locos.

You can down load information  from CVP Products

Allen

[SERABILL]

If the transmitter and receiver are new, you don't have to do anything to progtam them. By default, they are both on frequenct 0 and set to an address of 3.

Do you need specific instructions on the receiver and/or transmitter? 

 

[Run the Town]

I was not getting any connection between the 2 so I called and talked to Al.  Over the phone we walked through it and still no luck.  Speaking with a fellow hobbiest on the phone after that, he convinced me the wiring was misplaced so I changed it and fried the decoder.  So..... it is now with Al at airwire and he is checking the extent of the damage.