LIONEL FASTRACK

[lionelsoni]

John, that's for trimming the width.  But there are topics somewhere on the forum about shortening the length.  The main idea is to take it out of the middle, so that the connections are not disturbed on either end.

[csxt30]

Here's a link we have from on top of the forum for cutting fastrak !

http://www.trains.com/trccs/forums/1028152/ShowPost.aspx

Thanks, John

[dgraham]

Cutting Fastrack is not hard to do.  I modified several pieces in making my floor layout and they look and work fine.

[Anonymous]

closest you will get is three 1.75 which wil get you 5.25 or like said. Cut a 10" to 5.5".

Incorrect.  Lionel is releasing a 1 3/8" section with and without the roadbed.  4  1 3/8" sections will get you 5 1/2 inches.

Nothing wrong with using FasTrack either...

Now if we could only get Lionel to release FasTrack section in 1/8 inch increments from 1" to 40" that would be the ticket!!! 

[EIS2]

Have you considering revising your layout plan so that it only requires standard pieces?  That is what I do.  Cutting Fastrack does not seem like a good idea. 

If anyone from Lionel reads this post, Kato N-Scale Unitrack has a very nice expansion piece P/N 20-050.  An expansion piece for FasTrack would be ideal for situations such as these.

Earl

[Dave45681]

If there is a 10" length of straight on a parallel path on the other side of the loop, replace it with a 4.5" combined with a 5" (for 9.5").  The 1/2" shorter straight run on the other side will narrow your gap on the side in question from your 5 1/2" to 5", which of course does exist.

Still uses an extra track section, but I would prefer that to cutting or using 3 of the really small pieces.

  

[riverrailfan]

closest you will get is three 1.75 which wil get you 5.25 or like said. Cut a 10" to 5.5".

[chuck]

I believe 4 units of the 1 3/8" sections will yield a 5 1/2" section of track.  Lionel part number is 6-12073.

1  3/8 = 11/8 * 4 = 44/8 = 5 1/2 

[crip]

 IS THERE ANY LENGTH OF STRAIGHT ON EACH SIDE OF THE 5-1/2 TRACK?

                               MARK

[lionelsoni]

Cut 4.5 inches out of the middle of a 10-inch piece.

[SD-40T-2]

 I AM BUILING THIS LAYOUT  THAT  REQUIRS  51/2" STRAIGHT  5 PC  ARE REQUIRED  HOW CAN  I MAKE A 5" INTO A 51/2"  THE FASTRACK  STRAIGHT  IS 5 "  I NEED 51/2 " STRAIGHT