tips for installing TMCC

[Joe Hohmann]

The "good ground" is especially true where the Command Base is plugged-in. It should be plugged-in DIRECTLY to a grounded wall receptical, or if using a power strip, plug it into a 3-prong adapter, run a wire from the adapter ground prong to a radiator or water pipe, THEN plug into the power strip. I didn't realise the importance of this, thinking these were simply "safety" tips. Joe

[ChiefEagles]

TMCC needs a good ground.  My layout is divided into three real blocks.  One for each loop and then all the sidings are insulated from the main lines [mini blocks but run off of the same buss bar].  I had my Command Base under my layout with the transformers and DCS TIU.  I got some signal problems so I brought it up to the top.  Since then, no problems.  Tracks running over tracks sometimes gives signal problems.  A grounded wire running over the track below helps.  Some use "rabbit wire" in tunnels and etc.   Hook it up and it will probably work fine.

[Anonymous]

I just bought me a new ZW, with a tmcc commander and cab 1, when I install this setup, is there any thing I need to keep an eye out for when rewiring? Currently I have 2 blocks, one on each loop of track, with multi feed drops from a central terminal strip under the layout. Some of my track power and accessory power runs together as it travels under the layout from distribution block to the individual accessory.