Just Updated two Beeps to Command Control by www.electricrr.com

[jimhaleyscomet]

Dr. John, 

I had to go with an older version (Edition 5, published 1995 or 1996).  I figure the prices might be a little off but I can update the ones I am interested in by watching ebay.  Plus it should be good to keep me from way overpaying. 

Jim H

[dougdagrump]

The Docksiders can be upgraded but I can't remember which boards are used. However, I believe the only thing that could not be included was the sound, insufficient room.     

[dwiemer]

Buckeye, I read some posts a while ago regarding the docksider and putting a board in it to upgrade.  First, they had problems getting into the engine, second, they did not have enough room to put it in.  I have not personally opened up my dockside, so I can only go on hearsay.

dennis

[ChiefEagles]

Good.  I've upgraded GP9's and old U36B's with kits from Digital Dynamics.  Buckeye, probably will work as I think the limiting factor is AMP draw from the motors.  The small motors work well with them.  DD has the mini boards too.

[jimhaleyscomet]

I am not sure about docksider, but if you send him an email he is very good about answering.

Jim H

[Buckeye Riveter]

Jim, thanks for the info.  The video on the website really sells the product.  Do you know if the BEEP TMCC kit works for the Lionel Docksider? 

[jimhaleyscomet]

I just updated two beeps to TMCC with a kit ($65 each) from www.electricrr.com. I did not add sound (I have a sound car for that).  It was a no solder installation which is good because I am not fond of electrical work, especially soldering around expensive boards.  I was nervous cutting wires off the existing reverse board, no turning back now!  The instructions were very clear and the units are now working!  The nice thing about beeps is I can always switch shells, I do not have to fork out the money to convert all my Beeps to command. 

The beeps seem to stall less on switches as now I run the track at 18V and the lights are much brighter.  I highly recomend this installation even if you are timid about electrical modifications (like me!).   I think he also sells beeps with TMCC already installed for $100.  If I had it to do over that is the route I would take. 

Jim H