Trains.com

Growling noise and slowing down

743 views
5 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    January 2006
  • From: Foothills of Wva
  • 691 posts
Growling noise and slowing down
Posted by Fred Bear on Saturday, August 26, 2006 8:08 PM
I think this is the second time I've written about the same problem, different engine however. The Lionel 8702 Southern Crescent I just purchased growls and slows down at different places on the track, just random places. Does anyone know what causes this? and if it's the brushes, does anyone know what part number for the brushes? Thanks to all, Jake
  • Member since
    December 2004
  • 3,176 posts
Posted by csxt30 on Saturday, August 26, 2006 8:37 PM

Jake : if you do need brushes, you can email Jeff at this site;  http://www.ttender.com/

Also, you might try this site ; http://www.olsenstoytrainparts.com/, they are a bit hard to search at & you can email them also.

Hope this helps & someone may come along with another solution .

Thanks, John

  • Member since
    February 2004
  • From: Rolesville, NC
  • 15,416 posts
Posted by ChiefEagles on Saturday, August 26, 2006 10:42 PM
Check the lube.  Seen them get "dry" and gears try to bind.  Turn it over, put alligator clip on center rooler and the common on the frame.  Run it upside down and see where binding. 

 God bless TCA 05-58541   Benefactor Member of the NRA,  Member of the American Legion,   Retired Boss Hog of Roseyville Laugh,   KC&D QualifiedCowboy       

              

  • Member since
    January 2006
  • From: Foothills of Wva
  • 691 posts
Posted by Fred Bear on Sunday, August 27, 2006 7:42 AM
Thanks, I'll give these ideas a try and see what shakes out of the tree. Do ya'll think it's the brushes? Will that make the motor slow way down, then back up to full speed and make a growling noise? Thanks, Jake
  • Member since
    August 2006
  • From: N.E. Ohio
  • 49 posts
Posted by weldman87 on Sunday, August 27, 2006 8:36 AM
I  would try lubing like Chief Eafles suggested. If the brushers were bad your engine would not run at all or would make a lot of sparks out of the motor. the comutator where the brushes are would be burnt if the brushes were bad. good luck
  • Member since
    August 2005
  • From: Florida
  • 409 posts
Posted by otftch on Sunday, August 27, 2006 9:27 AM

We ran a Polar Express engine at shows and had the same problem.It would slow down periodically for no reason.Sometimes after two minutes,sometimes after an hour,but it would constantly slow down.I lubed it,test ran it,ceckled evrything I could think of.Finally it started growling as it slowed down.I thought the problem was in the motor.In desperation I totally dissasembled it and found the axle shafts were dry,and I was using a needle point oiler.Seems the tolerances are that close.I lubed the shafts while it was apart and have had no more problems.I'm not sure this is your problem but I thought I'd let you lnow.

                               Ed 

"Thou must maintaineth thy airspeed lest the ground reach up and smite thee."

Join our Community!

Our community is FREE to join. To participate you must either login or register for an account.

Search the Community

FREE EMAIL NEWSLETTER

Get the Classic Toy Trains newsletter delivered to your inbox twice a month