connecting track sections o27

2 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    October, 2008
  • 233 posts
Posted by Papa_D on Tuesday, December 04, 2018 5:48 AM

if you haven’t done this yet, hold one piece at a right angle to a second piece and insert one pin at a time in each of the three rails. This normally makes it easier to then connect the two track ends with a tight fit.

  • Member since
    April, 2013
  • 251 posts
Posted by Michael6268 on Monday, December 03, 2018 4:06 PM

In general you would not want gaps on every piece of track on every rail. Occasionally there's some pieces that just don't fit right and you'll have one or two of the rails 1/8" shorter. But if they're all that way, you should try to get them tighter. Straights, I usually take a block of wood and try to hold one piece of track tight, while tapping the block of wood against the other piece of tracks butt end.  That usually gets them tight.  Curves are a bit tricky.

  • Member since
    December, 2018
  • 1 posts
connecting track sections o27
Posted by dumbguy302 on Monday, December 03, 2018 10:41 AM

My wife is trying to ressurect her dad's Lionel Junior train. She oredered track which has very tight tollerance between pin and tube. I understand that tight is good but the gaps between sections are over 1/8". Is this acceptable?

Join our Community!

Our community is FREE to join. To participate you must either login or register for an account.

Search the Community


Get the Classic Toy Trains newsletter delivered to your inbox twice a month