Joined 1-21-2011 TCA 13-68614
Kev, From The North Bluff Above Marseilles IL.
Kevin ask Jeff for a idea before you buy another motor.
Life's hard, even harder if your stupid John Wayne
http://rtssite.shutterfly.com/
KRM For those who care about more than Santa's address: I pulled the shell today and un-hooked the e-unit and hooked a 9 volt battery to the motor like SJ suggested and the motor seems to work fine. I will order a new e-unit install it, and let you know if that repairs the problem.
For those who care about more than Santa's address:
I pulled the shell today and un-hooked the e-unit and hooked a 9 volt battery to the motor like SJ suggested and the motor seems to work fine. I will order a new e-unit install it, and let you know if that repairs the problem.
Well that did not work!!!!
Why I started this thread in the first place, to get some help deciding what I needed to do. Not get Santa's address:
So now,,,
Guess I will order a new motor.
sir james I What does Santa Clause have to do with Kevins engine problem?
What does Santa Clause have to do with Kevins engine problem?
Good question SJ, Guess I will just have to go it alone. For now I will wait till the weather gets bad and I can't do stuff outside. Then I will pull it apart.
"IT's GOOD TO BE THE KING",by Mel Brooks
Charter Member- Tardis Train Crew (TTC) - Detroit3railers- Detroit Historical society Glancy Modular trains- Charter member BTTS
Good to see everyone having some fun with this!!!!
Well, if Santa lives in Lake Placid the Adirondack Scenic Railroad should seek him out and get him on board, they could use his pull! They've been getting an awful lot of grief from the NIMBY's and outdoor eliteists up there.
You can check out the whole sordid story on the "Trains" Forum, look for "Steam and Preservation" and start scolling down.
I mean, who's going to say "no" to the Great Man, Mr. C himself? I wouldn't!
Even the nicest guy on Earth is going to have his limits!
Santa is at Zip Code 12946.
Rob
H0 is part of Santa Claus's Canadian postal code (H0H 0H0). It is strange that he would have a Canadian code, because he actually lives at US zip code 99705.
Bob Nelson
HO? Oh, it's that smallish gauge the rivet-counters over on the "Model Railroader" site obsess about. O gaugers like us frequently refer to it as "How Ordinary!"
Although, some HO accessorys can prove useful at times, as I mentioned earlier. Frequently you can pick up a used HO transformer useful for checking DC motors dirt cheap at train shows, among other places.
HO????? What is HO????
You can run the motor with an HO transformer as well, they're DC output, but as the man says, disconnect the E-board.
sir james I You could test the motor with a 9 volt battery but disconnect the e unit first.
You could test the motor with a 9 volt battery but disconnect the e unit first.
thanks SJ, I will try that.
Every thing is clean and good the Loco has been lubed and always ran fine. The engine I replaced it with runs just great on that loop.
It is the loco. Motor or e-board. Not sure how to test the motor alone because it is a DC motor thanks to the board??
Guess I will pull the shell next bad day.
Slowing to a crawl?That makes me think hair, carpet pile, piece of traction tire, or some other foreign material is probably wrapped around the gears and/or wheels. I'd use a pin, needle, or tweezers to pull out anything that could be clogging up the works around the gears or wheels.
Once you remove all matter you find, add a couple of drops of oil to the gears.
If that doesn't work, then the only other thing I can think of is to oil the motor itself. Obviously, you'd have to take the shell off. Make sure there isn't anything clogging the motor and then oil the shaft. I don't think there's anything wrong with the motor itself, because it is moving. Friction and foreign matter are usually the only things that affect the speed of the motor (not counting any change in supplied voltage). Of course if the engine was dropped or thrown, then it's possible something's broken. Most engines are very durable. They take a lot of abuse, so it probably isn't likely.
Wish I was there to see and hear it.
How does any other locomotive run on the kids track? Reason I'm asking is to eliminate any track or transformer problems. Probably stating the obvious to you but if any other engine works fine then there's something wrong with that 0-8-0.
Motor? If it's possible see if you can meter the motor leads to see if it's getting enough juice. If so, then it's a motor problem, if not, then it's the E-board.
Could even be a loose wire in there somewhere.
I'd assume it's out of warranty by now if you feel OK with taking it apart.
I'll tell you, these modern locomotives with all their electronics are making the surviving post-wars more and more attractive.
Our community is FREE to join. To participate you must either login or register for an account.
Get the Classic Toy Trains newsletter delivered to your inbox twice a month