Layout build problem

[bigdogjeff]

I am making a one line dogbone layout with a bascule bridge in the middle but found 1 problem my mth gg1 not going to go through the bridge what have others done with this problem.

[lionelsoni]

Make a little loop of (black) thread between the top and bottom of the pantograph to restrain it at a safe (and more realistic) height.

You can also increase the bridge clearance about a half-inch by removing one truss piece over the bridge entrance farthest from the pivot, but this alone is not enough for the GG1.

[bigdogjeff]

Thanks for the reply I will see if I can do the thread since they are working panographs I May just turn them off.