Barrel Loader questions/problems

[Chris F]

Jerry,

Here's the link for the #32996 modern version, which shows where the clip goes -

http://www.lionel.com/products/productnavigator/InstructionManuals/73-2996-250.pdf

FYI - The rectifier disc is #1041-13. I'd recommend replacing the #395-29 insulation, too.

[ChiefEagles]

Get out the volt meter. Check and see if you are actually getting power. Go from there. Not familiar with the thing. good luck.

[Anonymous]

I got a berrel loader today, I hooked one hot terminal to one clip, and the ground to the other clip. this was all done on the R. I turned the proper knob on the R and... nothing. Flipeed the wires around...nothing.

Can you guys help me?

Heres a pic


I also cant find where the barrel loader ramp clip goes. It is the black strip on the main section.

---Got it to work a little bit, the platform will vibrate but the barrels can't make it up the ramp. I took it apart to inspect it, and the rectifier disk was corroded like heck. Could this be the problem?