I had an engine that messed up and jumped the track and it fried the powermast instantly so if you had that it will just work as a way to arr power to your track from your brick
Life's hard, even harder if your stupid John Wayne
http://rtssite.shutterfly.com/
Be sure the crystal is seated firmly in the PM-1. Set the TR ID to #1 following the manual. Be sure to set the PM-1 to "program" and use the "set" key behind the CAB-1 door. Move the switch to "run". Re-address TR#1 and hit "boost".
Set the momentum to "L"(low).
Check the troubleshooting manual.
Rob
My layout is set up for Lionel TMCC and uses a Power Master so that I can run in Conventional mode. It runs fine in Command mode, but when I move switch to "Conventional" mode nothing happens. I have tried reprogramming the Power Master (as suggested by Lionel) but this doesn't seem to correct problem. Any suggestions?
Our community is FREE to join. To participate you must either login or register for an account.
Get the Classic Toy Trains newsletter delivered to your inbox twice a month