lionelsoniI think that adding capacitive discharge would be difficult here, since he needs voltage of either polarity to run the single motor, which he gets by rectifying the transformer's AC output. The two solenoids of a conventional switch machine don't care whether they see AC, or DC of either polarity.
All you would need is a pair of inexpensive bridge rectifiers added, one for the "out" and one for the "through" circuits.
Rob
Dave,
I too like those 1022 switches, and have always used them for my yard. I have on occasion tried to find a good way to work them remotely without modifying them. Never found anything I really liked, but what you show is simple and interesting. Thanks for sharing, and the little movie clip to go along with. My railroad uses exclusively 1022, and 1122 switches which I have aquired quite a few. I have at time thought of the 042 -027 switches, but I like the postwar look the best.
Thanks Again,
Alan
Here is a short video of the switch in operation.
http://www.youtube.com/watch?v=2-M0JSeVWM4
Also, from All Electronics they have all the other parts for the remote switches.
The 3 amp diodes.
http://www.allelectronics.com/make-a-store/item/GI851/3-AMP-100-V-FAST-RECOVERY-RECTIFIER/-/1.html
Momentary pushbutton switches.
http://www.allelectronics.com/make-a-store/item/MPB-1/SPST-MOMENTARY-N.O.-PUSHBUTTON/-/1.html
Plastic case.
http://www.allelectronics.com/make-a-store/item/1551-KBK/BLACK-ABS-BOX-3.15-X-1.57-X-0.8-/-/1.html
On my layout I have 2 - 1022 switches with the added remote feature and I use a postwar 1122 switch controller instead of the plastic case and pushbuttons. There is plenty of room inside for the 2 diodes.
I think that adding capacitive discharge would be difficult here, since he needs voltage of either polarity to run the single motor, which he gets by rectifying the transformer's AC output. The two solenoids of a conventional switch machine don't care whether they see AC, or DC of either polarity.
Bob Nelson
Hi Rob,
Here is a motor that should work from All Electronics. It is similar to the Radio Shack motor and it's less expensive:
http://www.allelectronics.com/make-a-store/item/DCM-298/SMALL-POWERFUL-12VDC-MOTOR/1.html
Looks great!
You could also incorporate Bob Nelson's CD circuit into your wiring to make the 1022 non-derailing using track trigger sections as you would with 1121 switches.
Could you recommend a motor type(or specs) that might be available from a surplus house(All Electronics, eg.)?
Then attach the remaining strip to the bottom of the switch using double faced tape. Align the motor shaft directly opposite the switch arm pivot.
Assemble the 2 pushbutton switches and diodes in a small plastic project box and run wires to the AC accessory terminals of your transformer and to the motor using #18 or 20 gauge wire.
Our community is FREE to join. To participate you must either login or register for an account.
Get the Classic Toy Trains newsletter delivered to your inbox twice a month