671 engine side rod problem

|
Want to post a reply to this topic?
Login or register for an acount to join our online community today!

671 engine side rod problem

  • I'm rebuilding a 671 turbine engine. All has gone well but when I replaced the side rods they lock up. Anyone have an idea what might be happening or what I may have done wrong. HELP 

    Replies to this thread are ordered from "newest to oldest".   To reverse this order, click here.
    To learn about more about sorting options, visit our FAQ page.
  • I assume you're talking about a Lionel model of the PRR S2 class direct drive turbine loco.

    Do you have your drivers properly quartered?  Try putting a single siderod on, then rotating the drivers slowly.  All of the crankpins on the rod-free side should rotate in sync - all at the same angle.  If they don't, you will have to readjust the driver on the mis-quartered axle.

    If the drivers were not quartered exactly 90 degrees apart, turning one driver set end for end will cause the lockup you mentioned.

    For additional info, I would suggest placing this on the Classic Toy Trains forum.  That gets a lot more traffic and attention from knowledgeable people.

    Chuck