Edit topic

Updated your discussion topic below.

Subject
Enter a subject for your topic. Maximum 150 characters.
Post Body
Enter your post below.
Hi everyone, I have just received a Alco PA-1 from USA trains. It looks awesome, but it seems that the people at USA trains were a but cheap with the glue. Two of the windows were loose because they weren't glued properly. Because all windows are glued on the inside I had quite some problems getting them out of the train and putting them back with some glue. I did all of this with a finger through the rear door.. I removed the rubber diaphragam at the rear of the train to get better access. This worked, but replacing the rubber diaphragam without removing the body of the train seems impossible.. I think that the only way to get it right, will be by removing the body. Has anyone done this, or can tell me what screws I should expect to loosen? I already looked at the bottom, there are quite some screws, but it seems that I will also need to loosen the 'steps' + the connected detailing parts.. I am a bit afraid loosining too much and having trouble getting everything assembled again. When I succeed, I would also like to see if I can install a DCC decoder. Thanks for any help or suggestions. With kind regards, David
Tags (Optional)
Tags are keywords that get attached to your post. They are used to categorize your submission and make it easier to search for. To add tags to your post type a tag into the box below and click the "Add Tag" button.
Add Tag
E-mail Subscribe
Check the box below if you want to receive e-mail notifications when replies are made to this thread.

Receive notifications