Trains.com

145 Gateman light is dim unless I lower output on different ZW post

168 views
3 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    January 2021
  • 3 posts
145 Gateman light is dim unless I lower output on different ZW post
Posted by Bob Paris on Friday, April 30, 2021 11:24 AM

Building layout with ZW.  Post A for track power, B for 022 fixed voltage plugs, C for lights and D for accessories.  Main wires for these circuits and a ground wire run underneath & around the layout so I can feed off of them. I made insulated curve tracks to initiate operation of the 145 gateman and wired the accessory per the instructions on page 69 - Fig 10-6 of Greenberg's "Wiring Your Lionel Layout" so that the shack's light would be on all the time and the gateman action would be initiated when the train enters the insulated block.  For power I am feeding off of the wires from post C [lights] and D [accessories.] both set on the ZW at 14 watts.  When turning on the transformer, I noticed that the gateman shack's light was dim although the gateman action worked fine when the train passed.  I happened to reduce the power for post C to zero and the shack's light got brighter - if I raise the power from 14 [shack light is dim] to 16 watts the shack light goes out.  What am I doing wrong?  Thank you for your suggestions.

  • Member since
    January 2021
  • 3 posts
Posted by Bob Paris on Friday, April 30, 2021 4:40 PM

I figured out my error.  Of the three leads from the shack, one goes to power, one to ground and the other to the insulated ground rail.  All good now.  I also noted my error stating watts instead of volts and misleading title of post.  

  • Member since
    December 2001
  • From: Austin, TX
  • 10,028 posts
Posted by lionelsoni on Saturday, May 1, 2021 4:27 AM

o  What ZW do you have, a real postwar ZW or the modern one?

o  What AWG wire are you using?

o  Didn't you mean "volts" where you wrote "watts"?

Bob Nelson

  • Member since
    December 2005
  • From: Hopewell, NY
  • 2,979 posts
Posted by ADCX Rob on Saturday, May 1, 2021 12:54 PM

I can guarantee you didn't follow the wiring diagram exactly...  you can't use both C & D on your gateman. Use "D" only for both the light and the solenoid. The problem you are having is that C is referencing "D" instead of "U" for the return circuit on the bulb, which results in your exact symptom.

Rob

Join our Community!

Our community is FREE to join. To participate you must either login or register for an account.

Search the Community

FREE EMAIL NEWSLETTER

Get the Classic Toy Trains newsletter delivered to your inbox twice a month