Trains.com

Right Of Way Industries Saddleback 0-4-0 Tank Engine Questions

8846 views
14 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    April 2003
  • 305,205 posts
Right Of Way Industries Saddleback 0-4-0 Tank Engine Questions
Posted by Anonymous on Saturday, August 4, 2007 3:56 PM

I picked up this spiffy little brass engine - numbered 729 for Southern Rwy - at a train show today. Came with a nice dark red box. But - no manual. I have a couple of questions and was hoping one of you guys might have one of these.

First, it has a smoke unit. But it has a smokestack with the little projection in the middle of the stack. I seem to recall reading something about not using Lionel or MTH smoke fluid in one of these things, that they were a Scheiff (?) unit and regular fluid could damage them. Am I right about this? What fluid should I use?

Second, it does not appear to have a whistle or bell, at least nothing happens when I activate the requisite buttons on the transformer. Am I correct in assuming it lacks both?

Third, lubrication. Any suggestions for lubrication other than what I have already done - a light coating on the rods and small drops on the axels?

Thanks for any help. The thing seems a bit noisy, which is another issue.

  • Member since
    July 2006
  • From: Plymouth, MI
  • 1,615 posts
Posted by chuck on Saturday, August 4, 2007 4:08 PM
Smoke unit  is a Seuth.  It does use a different formulation for fluid with a lighter viscosity.  I believe the LGB stuff works well.
When everything else fails, play dead
  • Member since
    April 2003
  • 305,205 posts
Posted by Anonymous on Saturday, August 4, 2007 4:10 PM

 chuck wrote:
Smoke unit  is a Seuth.  It does use a different formulation for fluid with a lighter viscosity.  I believe the LGB stuff works well.

 

That's it - Seuth. Thank you! That's one question answered.

  • Member since
    July 2006
  • From: Plymouth, MI
  • 1,615 posts
Posted by chuck on Saturday, August 4, 2007 6:17 PM
ROW produced a Docksider back in the early 90's.  It had directional lighting, operating couplers a smoke unit and an electronic E unit.  No sounds (probably no room).
When everything else fails, play dead
  • Member since
    April 2003
  • 305,205 posts
Posted by Anonymous on Saturday, August 4, 2007 9:06 PM

Right-Of-Way did make a boxcar with sound for these engines. There should be 1 or 2 wire(s) at the back of the engine to connect with the sound car. I have seen one but I understand that these are scarce.

 

Steve 

  • Member since
    April 2003
  • 305,205 posts
Posted by Anonymous on Sunday, August 5, 2007 11:21 AM
There is indeed such a wire at the back and I had no idea what it was for. Thank you!
  • Member since
    July 2007
  • 2 posts
Posted by panz on Sunday, August 5, 2007 4:55 PM

Here are the entire Dockside Operating Instructions;

Engine operates best between 0-15V AC reversing switch is located under cab roof vent smoke unit on-off siwtch is located in front of smoke stack.

 This engine is wired for sound with the optional box car you can have whistle bell and chug and air pumps.

 This engine has been lubricated at factory so engine is ready to run.  Add light oil to axle bearings, side rods and roller pick ups.  and great to gear box after 1 hour break in time. 

 That's all that came with this engine, it's pretty neat and I wish I had that boxcar now. 

 John

  • Member since
    April 2003
  • 305,205 posts
Posted by Anonymous on Monday, August 6, 2007 11:06 AM
 panz wrote:

Here are the entire Dockside Operating Instructions;

Engine operates best between 0-15V AC reversing switch is located under cab roof vent smoke unit on-off siwtch is located in front of smoke stack.

 This engine is wired for sound with the optional box car you can have whistle bell and chug and air pumps.

 This engine has been lubricated at factory so engine is ready to run.  Add light oil to axle bearings, side rods and roller pick ups.  and great to gear box after 1 hour break in time. 

 That's all that came with this engine, it's pretty neat and I wish I had that boxcar now. 

 John

 

John, thank you very much. I very much appreciate your posting these. I've been hitting the poor lil thing with 18 volts.

Seems like a very well made engine and I truly love the detail. Not a huge puller but adequate - four scale boxcars and an MPC caboose is about its functional limit. But certainly adequate and very good, like a BEEP, for PW operating cars.

 I looked for that boxcar on ebay and got a resounding electronic, "Huh?"

  • Member since
    July 2006
  • From: Plymouth, MI
  • 1,615 posts
Posted by chuck on Monday, August 6, 2007 9:30 PM
The box car was of brass construction as well.  Try looking for 3150S (with Sound).
When everything else fails, play dead
  • Member since
    April 2003
  • 305,205 posts
Posted by Anonymous on Tuesday, August 7, 2007 9:26 PM
  • Member since
    April 2003
  • 305,205 posts
Posted by Anonymous on Wednesday, August 8, 2007 8:21 PM

I am going to look hard for the boxcar.

I will try to post a pic. Truly is a beautiful little engine. I was captivated by it.

  • Member since
    July 2009
  • 1 posts
Posted by PAUL'S TRAINS on Sunday, August 29, 2010 9:47 PM

I had a 2-6-6-2 C&O engine , ran very well, but no bell, whistle sounded like crap. I have another engine with the seuth smoke unit, works great with any smoke fluid.

  • Member since
    February 2010
  • From: Baden, PA
  • 96 posts
Posted by wm #734 on Wednesday, September 1, 2010 4:36 PM

       

  • Member since
    October 2022
  • 1 posts
Posted by rattler21 on Saturday, October 15, 2022 4:29 PM

I have the Chesapeake & Ohio 0-4-0 with the green Baltimore & Ohio Railway Express Agency boxcar with sounds.  It no longer fits our operation and I am going to sell them.  Where would be a good place to list them and what would be a fair price.  Thank you, John

Moderator
  • Member since
    May 2009
  • From: Waukesha, WI
  • 1,764 posts
Posted by Steven Otte on Monday, October 17, 2022 9:19 AM

This is your regular reminder that although it's OK to advise the above poster on places to sell his trains and how much to ask for them, this Forum prohibits direct buying, selling, and advertising.

--
Steven Otte, Model Railroader senior associate editor
sotte@kalmbach.com

Join our Community!

Our community is FREE to join. To participate you must either login or register for an account.

Search the Community

FREE EMAIL NEWSLETTER

Get the Classic Toy Trains newsletter delivered to your inbox twice a month