I'm using a MRC tech 6 to run my sound equipped locos from MTH and BLI. All the BLI respond as they should.
The MTH triplex sound does not start until I put it in DC then once the sound starts switch it over to the dual mode. i have to this every time I run the engine.
any suggestions?
There has to be a better way to get the sounds started.
Never had a Tech 6, but heard that it does both DC and DCC. However, I don't believe it has the capability to do DCS, which the MTH engine decoders use. MTH has supposedly worked on the DCS vs DCC coampatbility issue, but that is likely what's limiting what the Tech 6 can control except in DC.
Mike Lehman
Urbana, IL
DAVID FORTNEYThere has to be a better way to get the sounds started.
Have you tried hitting F3 (starup/shutdown)?
A quote taken from the MRC Instruction manual. You'll notice that it states that it will control NMRA compatible equipment, MTH is not NMRA, guide lined. So, I don't know what to say, I don't have any experience with it....Hopefully someone does...if not, call MRC, is the only advice I could give.
''Thank you for purchasing this new Tech 6 Train Control System. This advanced train control system can control two types of locomotives; standard, analog D.C. locomotives and new sound-equipped locomotives that contain N.M.R.A. compatible sound or non-sound decoders. The new Tech 6 line of power packs will take you beyond the 21st Century of train control.''
Take Care!
Frank
CSX Robert DAVID FORTNEY There has to be a better way to get the sounds started. Have you tried hitting F3 (starup/shutdown)?
DAVID FORTNEY There has to be a better way to get the sounds started.
Dave
This thread pushed me to get the tech 6. Ordered it the 2nd,delivered on the 3rd from train world. Now my Athearn challenger makes me smile.
cold steal This thread pushed me to get the tech 6. Ordered it the 2nd,delivered on the 3rd from train world. Now my Athearn challenger makes me smile.
I bought mine around 3 years ago and I love it..
I especially love the DC start volt,momentum and braking adjustments it offers since its the same as the DCC CV settings I use..
Gotta love the T-6 for the skilled switching it offers if one makes the DC adjustments I mention..
Larry
Conductor.
Summerset Ry.
"Stay Alert, Don't get hurt Safety First!"
oh wow,I have a lot to learn about this thing.One negative so far is the wire terminal will not hold in the wires. Screws just turn and turn without tightening. Am I doing this right?
No your not, if your looking where you put the screws the wire goes in the top section, tighten the screw and your set.
cold steal oh wow,I have a lot to learn about this thing.
oh wow,I have a lot to learn about this thing.