Trains.com

Subscriber & Member Login

Login, or register today to interact in our online community, comment on articles, receive our newsletter, manage your account online and more!

Detectable wheelsets, how do you make them?

2485 views
4 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    March 2007
  • 32 posts
Detectable wheelsets, how do you make them?
Posted by johnnyrails on Sunday, November 30, 2008 4:45 PM

Hello all...

can anyone direct me on the best , most inexpensive way to add detectable or resistor wheelsets to my HO scale rolling stock.

how easy is it to make them yourself?

where do you buy the components needed?

thanks,,,JR

  • Member since
    May 2002
  • From: Massachusetts
  • 2,899 posts
Posted by Paul3 on Sunday, November 30, 2008 5:18 PM

Sure, there's a couple ways.

One method is to solder a surface mount resistor (of the correct amount of ohms) from the back of the insulated wheel to the metal axle.  You'll have to scuff the soldering area and use flux, and be careful not to melt the plastic insulator around the axle.

Another is to drill a hole in the web of each wheel just a smidge bigger than the leads on a normal 1/4 watt resistor (1/2 watt is too big).  Then feed the resistor leads into the holes from the back, then bend over the leads and snip them.  The nice part about using this method is that you don't need a metal axle.

Yet another is to use a 1/4 watt resistor and two wheelsets with metal axles in an all plastic truck.  Flip one of the wheelsets over so that one insulated side is opposite the other.  Wrap the resistor leads around each axle, then snip the overage.  You can also glue the resistor to the truck bolster with a little Goo.

Let's see...  If you have metal trucks, you can mount the resistor in the car body with wire leads up through the floor.  The wires could be connected to the truck screws, or soldered to the truck frame.

Of course, you can also just add a track powered light of some kind (useful in cabooses and passenger cars).

Jay-Bee makes resistor wheelsets for about $2 per.

Paul A. Cutler III
*******************
Weather Or No Go New Haven
*******************

  • Member since
    February 2002
  • From: Reading, PA
  • 30,002 posts
Posted by rrinker on Sunday, November 30, 2008 5:20 PM

 Here's one method, all you need is CA, conductive paint, and some surface mount resistors. Most methods I've seen are variations of these.

http://mpmrr.net/resisted_wheels.htm

 

                                 --Randy

 


Modeling the Reading Railroad in the 1950's

 

Visit my web site at www.readingeastpenn.com for construction updates, DCC Info, and more.

  • Member since
    September 2007
  • From: Charlotte, NC
  • 6,099 posts
Posted by Phoebe Vet on Sunday, November 30, 2008 5:43 PM

Dave

Lackawanna Route of the Phoebe Snow

  • Member since
    October 2006
  • From: Western, MA
  • 8,571 posts
Posted by richg1998 on Sunday, November 30, 2008 5:58 PM

If you ever fall over in public, pick yourself up and say “sorry it’s been a while since I inhabited a body.” And just walk away.

Subscriber & Member Login

Login, or register today to interact in our online community, comment on articles, receive our newsletter, manage your account online and more!

Users Online

There are no community member online

Search the Community

ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT
Model Railroader Newsletter See all
Sign up for our FREE e-newsletter and get model railroad news in your inbox!