Programing a loco

[mikesmowers]

   I am trying to program an Atlas loco and cannot get it to work. I put the loco on the prograam track and press PROG and enter the last two digits of the loco 08 in this case, and press ENTER. The throttle says GOOD.  When I set it on the tracks it still runs on address 03.  Any help?

  I am still workng on the runaway loco that I posted about earlier.     Thanks.     Mike

[rrinker]

mikesmowers

   I am trying to program an Atlas loco and cannot get it to work. I put the loco on the prograam track and press PROG and enter the last two digits of the loco 08 in this case, and press ENTER. The throttle says GOOD.  When I set it on the tracks it still runs on address 03.  Any help?

  I am still workng on the runaway loco that I posted about earlier.     Thanks.     Mike

See my reply in the other thread. When in program mode on the program track you need to dial up AD2= on the left knob, NOT the address. When it says AD2=? you dial or key in 08 on the right knob and then press enter.

                           --Randy