These are the meazsurements that came off the physical models I have. not prototype drawings. I used a tool for measuring outside circumferences ( i cannt think of the name of it. Looks like a compass with the ends bent inward). I compared the widths to a scale rule and that is what I found the models to be. Most likely factory variation. Between a P2K S-1 and the Atlas RS11 measured at the point the two would be joined.
Wayne, that means the Atlas S-1 will much more closely match thier RS11 in width. A nominal difference if any.
Shane
A pessimist sees a dark tunnel
An optimist sees the light at the end of the tunnel
A realist sees a frieght train
An engineer sees three idiots standing on the tracks stairing blankly in space
drciesel Hi.. Say, where were you able to find Atlas RS-11 shells? None available on the Atlas site. Thanks in advance and good luck with your project! EDIT: Update, I did find some RS- 11 shells on Atlas, but they appear to be the old version with the molded on grabirons. I was looking for the newer ones.
Hi..
Say, where were you able to find Atlas RS-11 shells? None available on the Atlas site.
Thanks in advance and good luck with your project!
EDIT: Update, I did find some RS- 11 shells on Atlas, but they appear to be the old version with the molded on grabirons. I was looking for the newer ones.
You have to go into the exploded view sheets and find the model you want. Each of the parts is identified with a clickable number that takes you to the part. I find not al lavaliablee parts are listed on the parts pages for some reason.
NVSRR...The S-1 measure 5 foot wide. I looked up dimensions for a T6. And found the only drawings had photobucket plastered on it and were blurry. Useless. So which is right? 6 foot or 5 foot wide hood? Does the atlas S-1 have the same measurement?
No, I just now measured my older Atlas S-1, and its hood (not over the radiator louvres), measures about 5'9" or 5'10" in width.
Wayne
Seems odd, that site lists all the RS models (well, RS-1 to RS-3) as 5'05", I have huge doubts that the S1 is a foot and a half wider. You think it would be easy to find a top down view to compare the hood width to the track gauge.....
--Randy
Modeling the Reading Railroad in the 1950's
Visit my web site at www.readingeastpenn.com for construction updates, DCC Info, and more.
Thank you. I didnt find that one. Tells me the P2K is too narrow and tha atlas shell is much closer. Off to find atlas s-1
shane
I don't know anything about Alco's, but I did find this:
http://thedieselshop.us/DataS1S3.HTML
It says the engine hood is 6'10", the cab 10'.
This looks like a pretty handi site.
https://www.thedieselshop.us/
Mike.
My You Tube
The atlas RS11 shells have arrived. I realized i have two P2K s-1 here with all the guys and such. Even better, the door arrangement is correct for the T6. Just change out the radiator section. Yippee right. Nope. The atlas RS11 measures 6 foot wide. The S-1 measure 5 foot wide. I looked up dimensions for a T6. And found the only drawings had photobucket plastered on it and were blurry. Useless. So which is right? 6 foot or 5 foot wide hood? Does the atlas S-1 have the same measurement?