Edit topic

Updated your discussion topic below.

Subject
Enter a subject for your topic. Maximum 150 characters.
Post Body
Enter your post below.
Although it is only 80 % completed my area 3 is working proper;y after a lot of trouble. As the track comes out of the pumphouse tunnel, it goes through a left R 3 curve into a 4 % gradient then a right hand set of points (switch) to do with the reversing loop then still on 4 % it goes through a pair of left hand points back to back for the change over to the main loop from the reversing loop. I have had the following problems which seem to be all sorted out now:- 1/ derailments caused by bad camber (see previous subjects) 2/ Stalling, derailing and sticking on the points. 3/ locos unable to climb the gradient and lose traction. 4/ switch motors filling up with quarry fines due to the monsoons. 5/ Wash outs as item 4 6/ soil washing away over Vampires Tunnel as item 4. 7/ My accident where 6 little people were killed. 8/ concrete (cement) assemblies falling apart as the concrete didn't cure properly as it was too hot. 9/ The rear end of my ICE train getting filled with water, and blowing out its decoder chip see item 4 we had 75 mm (3") of rain in an hour or so one night. Etc etc etc but it is all working 100 % now. Rgds ian
Tags (Optional)
Tags are keywords that get attached to your post. They are used to categorize your submission and make it easier to search for. To add tags to your post type a tag into the box below and click the "Add Tag" button.
Add Tag
E-mail Subscribe
Check the box below if you want to receive e-mail notifications when replies are made to this thread.

Receive notifications